This is one strange problem that only started happening since October 2008. Have never seen it in my 4 years using Ghost v2003.793. It happens in different Windows computers and in different configurations.
Ghost in PC DOS mode does not see some partitions and folders that hold .GHO...
My Sony Viao VGN-SZ370P notebook computer cannot shut down automatically and completely (I have to push the power button for 5 second to turn off the power). It stays at a blank blue screen with a frozen mouse pointer. I did see this error message only once out of 50 incomplete shut down ...
It would be too complicate to figure out what is wrong with your booting. Your Windows XP is corrupted.
Repair XP with your XP CD. The repair will refresh XP and keep all else in place.
Start your PC with the XP CD. The very FRIST time that it ask you to Repair or Install XP, select Install...
Please read carefully.
You wrote, in your initial message, "have a copy of XP home from another computer".
And I said "Use the copy of XP Home CD to boot into Setup and perform a full format on Drive C. The key here is to perform a full format first before you perform a fresh install."...
There is a chance that your motherboard has gone bad and needs to be replaced.
But try this first.
Use the copy of XP Home CD to boot into Setup and perform a full format on Drive C. The key here is to perform a full format first before you perform a fresh install.
Writing over a previous...
How to telnet in to change a printers IP address?
So I open Command Prompt, type Telnet and then what? Like do I type the IP address of the printer after Telnet? After that, then what?
I have never done that before, so I only have questions.
Thanks in advance.
I am kind of guessing.
Can't you use the AutoCAD program CD to install again. The program installer might be able to detect the old program and give you an option to remove it first. Or it might simply install over the old one. Then you can remove it (along with the old).
My Windows 2000 Advance Server can not boot into logon screen.
The status bar just keeps on going on the first GUI screen (as Kernel is initialing) of Windows 2000 Server logo, unable to go to the logon screen. All other boot options/methods (safe Mode, Last known good config, Directory...
I keep getting this error message and cannot proceed when I tried to upgrade to IE 6 SP1:
ie6wzd.exe Entry Point Not Found
The procedure entry point CoInternetGetSession could not be located in the dynamic link library urlmon.dll.