1. Computer problem? Tech Support Guy is completely free -- paid for by advertisers and donations. Click here to join today! If you're new to Tech Support Guy, we highly recommend that you visit our Guide for New Members.

Alenware Aurora Front door connector/PSU issues

Discussion in 'Hardware' started by davidflynn12, Oct 15, 2008.

Thread Status:
Not open for further replies.
  1. davidflynn12

    davidflynn12 Thread Starter

    Joined:
    Feb 13, 2008
    Messages:
    26
    Recently Swapped out my old enermax PSU for a new one. Plugged everything back in. I inadvertenly disconnected a a twin wire two prong cable which connects to the hinge of thefront door of the tower. It is tied into the other connectors for the system pannel(20 pin) connector on the motherboard. However i do not know where it plugs in?

    I would not normally care but the PC will not power up with the new PSU. All i am getting is the standby power LED on the motherboard to light up. I have connected the two fans to the same cables as the EZ_plug( which i just use a ordinary four prong connector). The DVD and CD-R drives use the same power cable. The HDD i have using a SATA power connector. Finally the floppy drive just uses a standard connector with nothing else on the other 12v connectors. The motherboard uses a ATX connector, EZ_plug and 24 pin connector.
    I just realised i connedted the PSU up incorrectly. I used an EZ_plug with the ATX connection which i should not do with a Geforce 7800 GT on Asus A8N-SLI Deluxe(ez-plug should only be used with two cards). I also forgot to connect the six prong connector on the video card. Would this earlier omission on my part have damaged the mobo? I rectified and still no change?
     
  2. davidflynn12

    davidflynn12 Thread Starter

    Joined:
    Feb 13, 2008
    Messages:
    26
    The connector is for LED which can be installed in the door. I twisted ALienware's arm to answer this. On rechecking my system connection panel, i discovered my pwr switch connect was wrongly connected into the wrong slot(my fault)!I installed a new hard drive as well and my system now appears fixed and stable. I am hoping the inital problems with with system resets, usb connections and damaged file segments on HDD were to do with either the PSU or HDD. I hope the mobo is unaffected( i hope so the warranty ends in january). Any suggestions to ascertain if i need to check anything else would be helpful?
     
As Seen On
As Seen On...

Welcome to Tech Support Guy!

Are you looking for the solution to your computer problem? Join our site today to ask your question. This site is completely free -- paid for by advertisers and donations.

If you're not already familiar with forums, watch our Welcome Guide to get started.

Join over 733,556 other people just like you!

Loading...
Similar Threads - Alenware Aurora Front
  1. Kelvyn1804
    Replies:
    1
    Views:
    87
Thread Status:
Not open for further replies.

Short URL to this thread: https://techguy.org/759502

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice