Belkin KVM switch not working

Status
This thread has been Locked and is not open to further replies. Please start a New Thread if you're having a similar issue. View our Welcome Guide to learn how to use this site.

Siten0308

Thread Starter
Joined
Jun 29, 2007
Messages
39
Hello,

I have got a Belkin KVM switch model: F1DP108G, and I have 6 servers connected to it, however the 7th server is having trouble using the monitor. the 6 servers are old dell servers poweredge 1450, but the 7th server is a dell poweredge 1650 rack server. the Belkin KVM switch is different from the rest, it uses a cat5 cable instead of a 2 ps/2 and a vga, so using the Cat5, the other end is plugged into another device called SMB server interface module ps/2 model: F1DP101A-AP, then that device plugs into the servers. as i said all other 6 servers work fine, but the 7th gives this message on the screen when I switch to it, "DPMS standby mode" then I move the plugs around and it shows me this message after "frequency over range" please help.

Thank you
 
Status
This thread has been Locked and is not open to further replies. Please start a New Thread if you're having a similar issue. View our Welcome Guide to learn how to use this site.

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

As Seen On
As Seen On...

Welcome to Tech Support Guy!

Are you looking for the solution to your computer problem? Join our site today to ask your question. This site is completely free -- paid for by advertisers and donations.

If you're not already familiar with forums, watch our Welcome Guide to get started.

Join over 807,865 other people just like you!

Latest posts

Staff online

Members online

Top