1. Computer problem? Tech Support Guy is completely free -- paid for by advertisers and donations. Click here to join today! If you're new to Tech Support Guy, we highly recommend that you visit our Guide for New Members.

Bent HyperX Headphone cord

Discussion in 'Hardware' started by Expressetti, Jan 2, 2019.

Thread Status:
Not open for further replies.
  1. Expressetti

    Expressetti Thread Starter

    Joined:
    Jan 2, 2019
    Messages:
    1
    The end of the cord on my HyperX Stinger head phones (aka the part which is plugged into your device) is bent and I don't know what I should do. Any Ideas?
     
  2. Oddba11

    Oddba11

    Joined:
    May 12, 2011
    Messages:
    7,672
    First Name:
    Jim
    Once they are bent, they are usually trash.

    For it to work, it will need to be straight. But the metal from which they are created will usually break when you attempt to straighten it. You can try to straighten it, just be prepared to replace the headphones.


    On a side note, you can get replacement jacks. However, it would need to be soldered on, and the wires used in headphone cables is difficult, at best, to solder.
     
As Seen On
As Seen On...

Welcome to Tech Support Guy!

Are you looking for the solution to your computer problem? Join our site today to ask your question. This site is completely free -- paid for by advertisers and donations.

If you're not already familiar with forums, watch our Welcome Guide to get started.

Join over 733,556 other people just like you!

Thread Status:
Not open for further replies.

Short URL to this thread: https://techguy.org/1221319

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice