Tech Support Guy banner
Status
Not open for further replies.

Building PC

668 views 1 reply 1 participant last post by  Piano Man 
#1 ·
I have put together a DDR Epox mother board, 256 pc 2100 Kingston Value Ram, 32mb radeon all in wonder, maxtor hardrive, and a NEC DVD drive. The problem is I can't load windows I am getting a Disk Boot failure from the dvd drive.I am getting failed to load DOS when I tried to load max blast ver.1.24 from a floppy. It will boot into maxblast 1.27 but freezes up in the welcome screen. The system does go through post and counts all of the ram. I have ran the max blast powermax without any problems and the harddrive passes all the test. I have also tried to swtich ram with no luck. I have set jumpers, the only thing I wasn't sure about was the cpu and ram voltage adjusters. I set both to 0. the RAM was defaulted to .1 which would make it 2.6 volts.
 
G
#2 ·
"the only thing I wasn't sure about was the cpu and ram voltage adjusters. I set both to 0. the RAM was defaulted to .1 which would make it 2.6 volts."

You mean in your BIOS right? What is your CPU and what speed?

Piano Man
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top