cisco 2514 router and dsl

Status
This thread has been Locked and is not open to further replies. Please start a New Thread if you're having a similar issue. View our Welcome Guide to learn how to use this site.

Mrfoad

Thread Starter
Joined
Aug 7, 2000
Messages
28
I have a cisco 2514 router, a dsl line, and 5 machines running 98,nt, and 2k. I would like to run my dsl line into my router and allow the 5 machines to share the line. I'm pretty sure I need to configure NAT on the ethernet ports, but am a bit unclear on a few areas. First, (these are hypothetical #'s) if my ip address(from provider) is say 4.60.224.74, and my subnet is 255.255.252.0, and my default gateway is 4.61.224.1. How would I configure my two ethernet ports? Port0 will have the dsl line running into it, and the eth1 port will have a connected hub with the 5 machines. Any advice will be greatly appreciated, I've been trying to find an answer for along time now
 
Joined
Jul 29, 2001
Messages
21,334
Set up the DSL modem with the static IP address and have the other PC's use it as a gateway. Take the DSL ethernet and go to the hub/switch you shouldn't need another router.
 
Status
This thread has been Locked and is not open to further replies. Please start a New Thread if you're having a similar issue. View our Welcome Guide to learn how to use this site.

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

As Seen On
As Seen On...

Welcome to Tech Support Guy!

Are you looking for the solution to your computer problem? Join our site today to ask your question. This site is completely free -- paid for by advertisers and donations.

If you're not already familiar with forums, watch our Welcome Guide to get started.

Join over 807,865 other people just like you!

Latest posts

Staff online

Top