1. Computer problem? Tech Support Guy is completely free -- paid for by advertisers and donations. Click here to join today! If you're new to Tech Support Guy, we highly recommend that you visit our Guide for New Members.

DCC Config

Discussion in 'Networking' started by nellieff, Jan 6, 2002.

Thread Status:
Not open for further replies.
  1. nellieff

    nellieff Thread Starter

    Joined:
    Jan 6, 2002
    Messages:
    11
    I would like to Direct Cable Connect between the following:

    1) Windows XP
    - USB only ports

    2) Windows 98
    Serial (9 pin) only

    Is this possible? If so, is there a reference on this?

    Thanks!
     
  2. Rockn

    Rockn

    Joined:
    Jul 29, 2001
    Messages:
    21,334
    You could also use the parallel port.....I don't think there is support or the USB with DCC.
     
As Seen On
As Seen On...

Welcome to Tech Support Guy!

Are you looking for the solution to your computer problem? Join our site today to ask your question. This site is completely free -- paid for by advertisers and donations.

If you're not already familiar with forums, watch our Welcome Guide to get started.

Join over 733,556 other people just like you!

Loading...
Thread Status:
Not open for further replies.

Short URL to this thread: https://techguy.org/64418

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice