Tech Support Guy banner
Status
Not open for further replies.

Network Adapter Properties {Moved to Networking}

589 views 1 reply 2 participants last post by  ich 
#1 ·
When I click on the properties tab for my NIC in Workstation 4.0 I get "cannot configure software component" message, how do I resolve this? I am trying to figure out my network settings. IE: Full or Half Duplex.
 
#2 ·
This isn't a tip or trick. I'm going to transfer this over to the Networking forum.
Check for updates there

Well, I can't seem to move it. I've alerted TechGuy and this thread will be moved shortly.

[This message has been edited by ich (edited 08-29-2000).]
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top