Network card setup in Server 2008 R2

Status
This thread has been Locked and is not open to further replies. Please start a New Thread if you're having a similar issue. View our Welcome Guide to learn how to use this site.

scs-04

Thread Starter
Joined
Jan 10, 2005
Messages
118
I am setting up a new Dell server that runs Server 2008 R2 and it has 2 network ports. What is the recommended way to setup those network ports. I have seen it setup where each network port has its own IP address on a different network. One port will have a 10.0.0.? address and is cabled directly to the internet router and then the other port will have an address of 192.168.1.? and is then cabled to the network switch with all the internal PC's. I have also seen it where 1 port is disabled and the other will have an address of 192.168.1.? and is connected into the switch with the PC's and the router. What is the preferred way to do this?? The server is on a small network with about 15 PC's and the server will be running DHCP and DNS. Is there a performance or security advantage to setting it up either way? Also we have a decent Sonicwall router connecting us to the internet. Any help or advice is appreciated.

Thanks
 
Status
This thread has been Locked and is not open to further replies. Please start a New Thread if you're having a similar issue. View our Welcome Guide to learn how to use this site.

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

As Seen On
As Seen On...

Welcome to Tech Support Guy!

Are you looking for the solution to your computer problem? Join our site today to ask your question. This site is completely free -- paid for by advertisers and donations.

If you're not already familiar with forums, watch our Welcome Guide to get started.

Join over 807,865 other people just like you!

Latest posts

Staff online

Members online

Top