hi there.
mandrake 8.2, HP845c printer
from http://hpinkjet.sourceforge.net/install.php
i downloaded hpijs-1.3
after i went to run window and tried to type
# tar xzvf hpijs-1.3.tar.gz
# cd hpijs-1.2
# ./configure
# make
# make install
i got an error reply, something like MAN VIEWER not set etc
any suggestions? i m really tired. i m new to linux and read all documentation but still cannot solve this
i tried to move to next step, in case that the "driver" was somehow already set during installation of mandrake.
to verify, i typed at run window:
# hpijs -h
same error reply
mandrake 8.2, HP845c printer
from http://hpinkjet.sourceforge.net/install.php
i downloaded hpijs-1.3
after i went to run window and tried to type
# tar xzvf hpijs-1.3.tar.gz
# cd hpijs-1.2
# ./configure
# make
# make install
i got an error reply, something like MAN VIEWER not set etc
any suggestions? i m really tired. i m new to linux and read all documentation but still cannot solve this
i tried to move to next step, in case that the "driver" was somehow already set during installation of mandrake.
to verify, i typed at run window:
# hpijs -h
same error reply