1. Computer problem? Tech Support Guy is completely free -- paid for by advertisers and donations. Click here to join today! If you're new to Tech Support Guy, we highly recommend that you visit our Guide for New Members.

Solved: G-tech g-raid2 repair question

Discussion in 'Hardware' started by Song_Edit, May 18, 2015.

Thread Status:
Not open for further replies.
  1. Song_Edit

    Song_Edit Thread Starter

    May 18, 2015
    I have two ext. HDs, both G-TECH G-RAID2 500GB (RAID 0) for MAIN & BACKUP. I replaced both disks in one unit and fans in both units with parts identical to originals. All important data was copied to a G-SAFE (RAID 1) HD before repairs were started. New disks for the second G-RAID2 HD will be replaced later. My computer is a Mac mini, OS10.7.5, 2.7GHz Core i7 with 16GB RAM & SSD.
    I need to know how to make the G-RAID2 HD address both disks to re-establish RAID 0. I see on the bridge circuit board a SW1 marking. Is that a switch? If so, what is it for? What do I need to do to get the G-RAID2 working as RAID 0 again? The Mac mini cannot mount the G-RAID2 HD with Disk Utility open because it is not yet operating as one volume. This is my first experience repairing a HD, so I need all the help I can get. My sincere thanks to anyone that can tell me what I need to do.
As Seen On
As Seen On...

Welcome to Tech Support Guy!

Are you looking for the solution to your computer problem? Join our site today to ask your question. This site is completely free -- paid for by advertisers and donations.

If you're not already familiar with forums, watch our Welcome Guide to get started.

Join over 733,556 other people just like you!

Thread Status:
Not open for further replies.

Short URL to this thread: https://techguy.org/1148415

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice