1. Computer problem? Tech Support Guy is completely free -- paid for by advertisers and donations. Click here to join today! If you're new to Tech Support Guy, we highly recommend that you visit our Guide for New Members.

USR Modem...disconnecting

Discussion in 'Hardware' started by shilo999, Jan 16, 2002.

Thread Status:
Not open for further replies.
Advertisement
  1. shilo999

    shilo999 Thread Starter

    Joined:
    Mar 8, 2001
    Messages:
    101
    Good day all..

    I have an internal US Robotics 28.8 Sportster Modem. Each time
    I try to connect... I can hear the "handshaking" however,
    it quickly gives me the error msg.." You have disconnected
    from the computer you dialed. Double click to try the connection
    again." I have adjusted the speed of the modem.. reinstalled
    it..etc to no avail. Its running off com3, irq 4.. if that helps.

    Any help would be appreciated...
     
  2. SavvyLady

    SavvyLady

    Joined:
    Oct 14, 2001
    Messages:
    2,218
    Verify your password & call your ISP if the # appears to be correct also.
    Sounds like an ISP problem though &/or
    you may need to update your dialup connector also
     
  3. shilo999

    shilo999 Thread Starter

    Joined:
    Mar 8, 2001
    Messages:
    101
    I have correct password..etc..
    Reloaded dial up networking..

    still same problem
     
  4. cwolfe98

    cwolfe98

    Joined:
    Jul 11, 2001
    Messages:
    606
    Faq.txt:
    ">>>To determine whether the serial port I/O address and IRQ
    settings are correctly defined:

    1. Click Start, point to Settings, click Control Panel,
    and then double-click System.

    2. Click Device Manager, and then click Ports.

    3. Select a specific port, and then click Properties.

    4. Click Resources to display the current resource settings
    for that port. To find the correct settings, consult
    your modem documentation.

    5. In the Resources dialog box, check the Conflicting
    devices list to determine whether the modem is using
    resources in conflict with other devices.

    6. If the modem is in conflict with other devices, click
    Change Settings, and then click a configuration that
    does not have resource conflicts.

    NOTE: Do not use a modem on COM3 if there is a serial
    mouse or other device on COM1. Usually, COM1 and COM3
    ports use the same IRQ and cannot be used simultaneously
    on most computers. The same is true of the COM2 and COM4
    ports. If possible, change the COM3 and COM4 port to an
    IRQ setting that is not in conflict.

    Also, some display adapters have an address conflict
    with COM4 ports. To work around this conflict, use
    another COM port or replace your graphics adapters.
     
As Seen On
As Seen On...

Welcome to Tech Support Guy!

Are you looking for the solution to your computer problem? Join our site today to ask your question. This site is completely free -- paid for by advertisers and donations.

If you're not already familiar with forums, watch our Welcome Guide to get started.

Join over 733,556 other people just like you!

Loading...
Thread Status:
Not open for further replies.

Short URL to this thread: https://techguy.org/65152

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice