1. Computer problem? Tech Support Guy is completely free -- paid for by advertisers and donations. Click here to join today! If you're new to Tech Support Guy, we highly recommend that you visit our Guide for New Members.

washing machine wont rinse

Discussion in 'Do It Yourself (Not Computer-Related)' started by 1randy, Jun 5, 2012.

Thread Status:
Not open for further replies.
  1. 1randy

    1randy Thread Starter

    Jun 5, 2012
    the washer will run until it gets to the rinse cycle. once there the cold water only trickles out and the rinse cycle never begins. i can fill it up from the start then set to spin and it works. i looked at the intake and the filters are clean and there are no kinks in the hoses. no idea why the cold doesnt work in the rinse cycle.
  2. Oldngrumpy


    Jan 7, 2012
    Will the washer fill in the wash cycle on "cold" setting? If not, you may need a new fill valve (where the hoses connect). If the cold wash works then there must be a bad circuit (solid state) or jumper (manual dial type) in the timer. Hope for the fill valve, as it's lots cheaper. Always check for loose or disconnected wires at the parts in question after disconnecting power. A bare connector spade and a dangling wire are likely meant to go together and a simple push of a wire could save you a service call.
As Seen On
As Seen On...

Welcome to Tech Support Guy!

Are you looking for the solution to your computer problem? Join our site today to ask your question. This site is completely free -- paid for by advertisers and donations.

If you're not already familiar with forums, watch our Welcome Guide to get started.

Join over 733,556 other people just like you!

Thread Status:
Not open for further replies.

Short URL to this thread: https://techguy.org/1055964