WRT54G Mesh Networking?

Status
This thread has been Locked and is not open to further replies. The original thread starter may use the Report button to request it be reopened but anyone else with a similar issue should start a New Thread. Watch our Welcome Guide to learn how to use this site.

gotrootdude

Thread Starter
Joined
Feb 19, 2003
Messages
8,812
Would like to set up a Mesh network around my neighborhood using several modified WRT54G's. I have several cake pan antennas (24db gain), 25 RF2365 2.4ghz low noise 20db amplifiers, a few 500mw signal boosters, and a 15db gain omni RV antenna.

What do I need to do to get the WRT54G's to mesh? Do I need to install OpenWrt, or can it be done with Sveasoft firmware?
 
Joined
Sep 14, 2003
Messages
1,240
I'd say openwrt is the best for this application, I'll have to check my config to see if the Sveasoft firmware can act as a repeater.
 
Status
This thread has been Locked and is not open to further replies. The original thread starter may use the Report button to request it be reopened but anyone else with a similar issue should start a New Thread. Watch our Welcome Guide to learn how to use this site.

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

As Seen On
As Seen On...

Welcome to Tech Support Guy!

Are you looking for the solution to your computer problem? Join our site today to ask your question. This site is completely free -- paid for by advertisers and donations.

If you're not already familiar with forums, watch our Welcome Guide to get started.

Join over 807,865 other people just like you!

Latest posts

Staff online

Members online

Top