Hi!
I got a new PC tonight, custom-built (from eBay) and I've been attempting to install Vista Home Premium x64 for the last 4 hours!
It supposedly had Vista pre-installed and was "ready to run" but the seller was obviously a liar. Because when I turn it on, this is what happens:
- a 'Biostar T-series' visual appears on the screen for a second (I don't know what that is)
- it then goes to a command screen with 'Hardware Monitor' and lots of CPU details
it then says:
Verifying DMI Pool Data ........
Boot from CD:
Press any key to boot from CD or DVD.....
A disk read error occurred
Press CTRL+ALT+DEL to restart
If I do press a key before the disk read error message appears it does bring me to the Vista installation screen. It then does install Vista, but when it gets to the point where the system needs to reboot, it just brings me back to the same command screen again.
I've tried to format the hard drive, and even attempted the system repair method (it found no problems with the system startup apparently). After I do the system repair process, instead of "A disk read error occurred", I get "BOOTMGR missing" instead, whatever that means.
At present, the computer is unusable, and I'm kinda pissed off cause I've wasted a whole night on this and will probably do the same tomorrow.
Any help would seriously be appreciated - thanks.
I got a new PC tonight, custom-built (from eBay) and I've been attempting to install Vista Home Premium x64 for the last 4 hours!
It supposedly had Vista pre-installed and was "ready to run" but the seller was obviously a liar. Because when I turn it on, this is what happens:
- a 'Biostar T-series' visual appears on the screen for a second (I don't know what that is)
- it then goes to a command screen with 'Hardware Monitor' and lots of CPU details
it then says:
Verifying DMI Pool Data ........
Boot from CD:
Press any key to boot from CD or DVD.....
A disk read error occurred
Press CTRL+ALT+DEL to restart
If I do press a key before the disk read error message appears it does bring me to the Vista installation screen. It then does install Vista, but when it gets to the point where the system needs to reboot, it just brings me back to the same command screen again.
I've tried to format the hard drive, and even attempted the system repair method (it found no problems with the system startup apparently). After I do the system repair process, instead of "A disk read error occurred", I get "BOOTMGR missing" instead, whatever that means.
At present, the computer is unusable, and I'm kinda pissed off cause I've wasted a whole night on this and will probably do the same tomorrow.
Any help would seriously be appreciated - thanks.